2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 622
Possible fault causes
- Speed sensors faulty
- Lines faulty
Fault setting conditions
- Rotational speed of shaft 1 or shaft 2 below threshold value
- Rotational speed of shaft 1 or shaft 2 above threshold value
Fault effects
- No power transmission
- Limp-home message in instrument cluster
Interchange Detected
P1760
Diagnosis information - PDK
Interchange detected
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
Possible fault causes
- Control unit is installed in the wrong vehicle
Fault setting conditions
- VIN in the control unit does not match the VIN on the CAN
Fault effects
- Adaptation values of the transmission are invalid
With P0603
P1760
Diagnosis information - PDK
PDK control unit, internal fault
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
Possible fault causes
- Control unit faulty
- Software faulty
Fault setting conditions
- Internal diagnostic routine returns fault
Fault effects
- Power supply switch-off for pressure regulator
- Solenoid valve power supply switch-off
- Hydraulic control is switched off
- Start enable only in position P
- Limp-home message in instrument cluster
With P0605
P1760
Diagnosis information - PDK
PDK control unit, internal fault
