2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 486
0 > 800 --> < 820
4 > 830 --> < 850
25 > 980 --> < 1000
37 > 1070 --> < 1090
Diagnosis Information - PDK (Dual-Clutch Transmission)
P0712
Diagnosis information - PDK
Transmission oil temperature sensor, signal implausible
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
Possible fault causes
- Line between temperature sensor and PDK control unit faulty
- Temperature sensor faulty
- PDK control unit faulty
Fault setting conditions
- Measured sensor voltage < 1.18 V
Fault effects
- An internal temperature substitute value is used
- Transmission limp-home indication in instrument cluster
P0717
P0717
Diagnosis information - Control unit DME (DFI)
Speed sensor Manual transmission
Diagnostic conditions
- Period since engine was started > 5 Second(s)
- Clutch Closed
Possible fault causes
- Loose contact or corrosion on connectors or lines
- Short circuit to B+/ground/between lines or open circuit in the lines
- Speed sensor Manual transmission Faulty
Fault effects
- Reduction Engine torque
Selector Lever Position Implausible
P0730
Diagnosis information - PDK
Selector lever position implausible
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
Possible fault causes
- PDK control unit faulty
- Selector lever control unit faulty
- Serial line between PDK control unit and selector lever faulty
Fault setting conditions
- Signal from CAN does not match serial data signal
Fault effects
- Transmission limp-home indication in instrument cluster
