2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 491
- Transmission limp-home indication in instrument cluster
Solenoid Valve 1 (Transmission Selection), Short Circuit To B+
P0754
Diagnosis information - PDK
Solenoid valve 1 (transmission selection), short circuit to B+
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following fault is not detected: P1832
- The following fault is not detected: P183A
Possible fault causes
- Line between solenoid valve 1 and PDK control unit, short circuit to B+
- Solenoid valve 1 faulty
- PDK control unit faulty
Fault setting conditions
- Internal current measurement, actuator solenoid R/P: current consumption = 0 mA
- Internally measured current is too high
Fault effects
- Solenoid valve switch-off
- Engaged gear is held until vehicle stops
- Moving off possible only in 3rd gear
- Transmission limp-home indication in instrument cluster control unit
Solenoid Valve 1 (Transmission Selection), Short Circuit To Ground
P0754
Diagnosis information - PDK
Solenoid valve 1 (transmission selection), short circuit to ground
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following fault is not detected: P1832
- The following fault is not detected: P183A
Possible fault causes
- Line between solenoid valve 1 and PDK control unit faulty
- Solenoid valve 1 faulty
- PDK control unit faulty
Fault setting conditions
- Internal current measurement, actuator solenoid R/P: current consumption = 0 mA
- Internally measured current value is too high
Fault effects
- Solenoid valve power supply switch-off
- Engaged gear is held until vehicle stops
- Moving off possible in all gears
- Transmission limp-home indication in instrument cluster control unit
Setpoint Definitions
P0754
Setpoint definitions
NOTE: The specified values and value ranges correspond to the OK state in each case.
