2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 180
then tested and any faults are stored.
- Ignition on
Possible fault causes
- Clutch faulty
- Hydraulics faulty
Fault setting conditions
- Tolerance value exceeded
Fault effects
- Deactivate all pressure regulators
- Emergency hold function
- Transmission limp-home indication in instrument cluster control unit
With P1958
P17E1
Diagnosis information - PDK
Plausibility check of shift rods
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following fault is not detected: P1731
- The following fault is not detected: P1732
- The following fault is not detected: P1733
- The following fault is not detected: P1734
- The following fault is not detected: P1706
- The following fault is not detected: P1707
Possible fault causes
- Hydraulic control unit faulty
Fault setting conditions
- Wrong shift rod moves in correct direction for even target gear
Fault effects
- Shift operation abort
- Old gear is engaged again
- Engaged gear is held until vehicle stops.
- Moving off possible only in 3rd gear
- No pre-engagement of next target gear
- Transmission limp-home indication in instrument cluster control unit
With P1957
P17E1
Diagnosis information - PDK
Plausibility check of shift rods
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following fault is not detected: P1731
- The following fault is not detected: P1732
- The following fault is not detected: P1733
- The following fault is not detected: P1734
- The following fault is not detected: P1706
- The following fault is not detected: P1707
