Friday, April 19, 2019

2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 605

2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 605



- Setpoint resistance < 2 Ohm



NOTE: The specified values apply only at an ambient temperature of approx. 20 锟斤拷C (68 锟斤拷F) (room temperature).



Displacement sensor setpoints



- Pulse-duty ratio (t / T ) > 10 % --> < 90 %



- Pulse-duty ratio, sensor faulty (t / T ) 95 %



Diagnosis Information - PDK (Dual-Clutch Transmission)



P1732



Diagnosis information - PDK



Shift rod 2 displacement sensors



Diagnostic conditions



The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are



then tested and any faults are stored.



- Ignition on



- The following fault is not detected: P1706



- The following fault is not detected: P1707



Possible fault causes



- Line between displacement sensor 2 and PDK control unit faulty



- Displacement sensor module faulty



- PDK control unit faulty



Fault setting conditions



- Duty cycle of displacement sensor 2 outside valid value range (10-90 %)



Fault effects



- Pressure regulator, system pressure, switch-off



- Pressure regulator, gear selection, switch-off



- Solenoid valves for gear cylinder selection, switch-off



- No R gear



- No emergency program diagnosis



- Last gear held



- Transmission limp-home indication in instrument cluster control unit



Shift Rod 1 Displacement Sensors



P1733



Diagnosis information - PDK



Shift rod 1 displacement sensors



Diagnostic conditions



The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are



then tested and any faults are stored.



- Ignition on



- The following fault is not detected: P1706



- The following fault is not detected: P1707



Possible fault causes



- Line between displacement sensor 1 and PDK control unit faulty



- Displacement sensor module faulty



- PDK control unit faulty



Fault setting conditions



- Duty cycle of displacement sensor 1 outside valid value range (10-90 %)



Fault effects



- Pressure regulator for system pressure, switch-off



- Pressure regulator for gear selection, switch-off



- Solenoid valves for gear cylinder selection, switch-off



- No R gear



- No emergency program diagnosis