2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 452
Fault setting conditions
- VIN in the control unit does not match the VIN on the CAN
Fault effects
- Adaptation values of the transmission are invalid
Diagnosis Information - Control Unit DME (DFI)
P0603
Diagnosis information - Control unit DME (DFI)
Control module Faulty
Diagnostic conditions
- Switch on ignition > 10 Second(s)
- then Idle speed > 30 Second(s)
- then engine speed > 1,000 1/min > 60 Second(s), at:
- Vehicle is stationary
- then Driving > 60 Second(s)
Possible fault causes
- Control unit DME (DFI) Faulty
Diagnosis Information - PDK (Dual-Clutch Transmission)
P0603
Diagnosis information - PDK
PDK control unit, internal fault
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
Possible fault causes
- Control unit faulty
- Software faulty
Fault setting conditions
- Internal diagnostic routine returns fault
Fault effects
- Power supply switch-off for pressure regulator
- Solenoid valve power supply switch-off
- Hydraulic control is switched off
- Start enable only in position P
- Limp-home message in instrument cluster
Double Fault: Two Faults Demand Alternative Measures With Equal Priority Rating
P0604
Diagnosis information - PDK
Double fault: two faults demand alternative measures with equal priority rating
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
Possible fault causes
- Analyse fault cause for faults also entered
Fault setting conditions
- Inadmissible combination of alternative measures