2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 482
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
Possible fault causes
- Control unit faulty
Fault setting conditions
- Internal diagnostic routine returns fault
Fault effects
- Power supply switch-off for pressure regulator
- Solenoid valve power supply switch-off
- Hydraulic control is switched off
- Start enable only in position P
- Limp-home message in instrument cluster
With P0603
P0706
Diagnosis information - PDK
PDK control unit, internal fault
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
Possible fault causes
- Control unit faulty
- Software faulty
Fault setting conditions
- Internal diagnostic routine returns fault
Fault effects
- Power supply switch-off for pressure regulator
- Solenoid valve power supply switch-off
- Hydraulic control is switched off
- Start enable only in position P
- Limp-home message in instrument cluster
Setpoint Definitions
P0711
Setpoint definitions
NOTE: The specified values and value ranges correspond to the OK state in each case.
Line test setpoints
Short circuit to B+:
- Setpoint voltage -0.5 V --> +0.5 V
Short circuit to ground:
- Setpoint resistance > 0.9 MOhm
Open circuit:
- Setpoint resistance < 2 Ohm
NOTE: The specified values apply only at an ambient temperature of approx. 20 锟斤拷C (68 锟斤拷F) (room temperature).
Temperature sensor setpoints
