2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 302
- Ignition on
- The following faults are not detected: P1731, P1732, P1733 or P1734
- The following faults are not detected: P1706 or P1707
- Alternative measure HSS3_OFF not active
Possible fault causes
- Hydraulics faulty (hydraulic control unit)
- Transmission faulty
Fault setting conditions
- Target gear Reverse gear, actual gear is disengaged before pressure adjusters 5/6 are activated
- 2. gear is engaged instead of reverse gear
- No shift rod moves
NOTE: The individual detection times are temperature-dependent (cold 2 s, warm 1 s)
Fault effects
- Gear held
- Only gears 1, 2, 4 and 7 are possible
- Transmission limp-home indication in instrument cluster control unit
Engagement Block, Synchronisation, Or Gear Skip
P176C
Diagnosis information - PDK
Engagement block, synchronisation, or gear skip
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following faults are not detected: P1731, P1732, P1733, P1734
Possible fault causes
- Clutch faulty
- Hydraulics faulty
Fault setting conditions
- Limit for number of permissible gear skips exceeded
Fault effects
- Reduced gear selection
- Transmission limp-home indication in instrument cluster control unit
Synchro Reverse Gear Not Disengageable
P176C
Diagnosis information - PDK
Synchro reverse gear not disengageable
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following faults are not detected: P1731, P1732, P1733 or P1734
- The following faults are not detected: P1706 or P1707
- Alternative measure HSS3_OFF not active
Possible fault causes
- Hydraulics faulty (hydraulic control unit)
- Transmission faulty
Fault setting conditions
- Reverse gear cannot be disengaged