2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 595
Possible fault causes
- Line between speed sensors and PDK control unit faulty
- Speed sensor 1 faulty
- Speed sensor 2 faulty
- PDK control unit faulty
Fault setting conditions
- Sensor supply voltage > 9.5 V
Fault effects
- Transmission limp-home indication in instrument cluster control unit
Sensor Supply Voltage 8.5 V Too High
P1707
Diagnosis information - PDK
Sensor supply voltage 8.5 V too high
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following fault is not detected: P0563
Possible fault causes
- Line between speed sensors and PDK control unit faulty
- Speed sensor 1 faulty
- Speed sensor 2 faulty
- PDK control unit faulty
Fault setting conditions
- Sensor supply voltage < 7 V
Fault effects
- Transmission limp-home indication in instrument cluster control unit
Setpoint Definitions
P1707
Setpoint definitions
NOTE: The specified values and value ranges correspond to the OK state in each case.
Line test setpoints
Short circuit to B+:
- Setpoint voltage -0.5 V --> +0.5 V
Short circuit to ground:
- Setpoint resistance > 0.9 MOhm
Open circuit:
- Setpoint resistance < 2 Ohm
NOTE: The specified values apply only at an ambient temperature of approx. 20 锟斤拷C (68 锟斤拷F) (room temperature).
Control unit setpoints
- Supply voltage for pressure sensor and displacement sensor 5 V
- Supply voltage for speed sensor 8.5 V
Diagnosis Information - PDK (Dual-Clutch Transmission)
P1707
Diagnosis information - PDK
Sensor supply voltage 8.5 V too low